User guide

160
Appendix J - Internal MMH2834 Composite Link Modem Commands
MMH2834 Modem Q Result Codes Enable/Disable Response
Configure &Q Result Code Selection
Command E Echo Command Characters
Responses V Result Code Terse/Verbose
(Section J.1.5) X Result Code...Basic/Extended/Call
Progress
MMH2834 Modem &T Remote Digital Loop Signal
Condition #T Enable/Disable Trellis Coded Modulation
Phone Line
(Section J.1.6)
MMH2834 Modem &D Data Terminal Ready Control
RS232C Interface
(Section J.1.7)
MMH2834 Modem #L0 Negotiate V42 Mode During Handshake
Configure #L1 MNP On/LAPM Off
Error #L2 LAPM On/MNP Off
Correction #L3 Direct LAPM/Phase Out Handshake
(Section J.1.8) $A Auto-Reliable Buffering
$F Enable/Disable Auto-Reliable Fallback
Character
$R Retransmit Count
$E Error Correction at 300 bps
MMH2834 Modem &BS Maximum Block Size
Compression & &E14 Data Compression Disabled
Block Size &E15 Data Compression Enabled
(Section J.1.9)
MMH2834 Modem $BA0 Speed Conversion On
Configure Speed $BA1 Speed Conversion Off
Conversion $MB Set modem speed (e.g.,$MB28800)
(Section J.1.10) $SB Set serial port speed (e.g.,$SB115200)
MMH2834 Modem $H Help
Execute I Product Code Inquiry
Immediate L5 List Current Operating Parameters
Action L6 List S-Register Values
Commands L7 List additional Configuration
(Section J.1.11) Parameters
L8 List On-Line Diagnostics