User guide
159
Appendix J - Internal MMH2834 Composite Link Modem Commands
Appendix J - Internal MMH2834 Composite Link
Modem Commands
J.1 Introduction
Before the internal MMH2834 composite link modem commands can be
entered, access to the modem has to be activated using the composite link
access (#CLA1) command. When the MMH2834 modem is configured, the
composite link access (#CLA0) command disables access from the
command port to the composite link. The following sections describe the
MMH2834 modem commands.
Table J-1. MMH2834 Command Summary
TYPE COMMAND DESCRIPTION
MMH2834 Modem D Dial
Dial A: or : Continuous Redial
(Section J.1.1) $D DTR Dialing
N Dial a Stored Number
MMH2834 Modem P/T Pulse/Tone Dialing
Modify Dialing &P Set Pulse Dial Ratios
Procedures , Automatic Pauses in dialing
(Section J.1.2) Y Long Space Disconnect
W Wait for New Dial Tone
R Reverse Mode of Operation
! Flash On Hook
$ AT&T "Calling Card" Tones
@ Quiet Answer
MMH2834 Modem D...N Store Phone Numbers
Memorize Phone NN Number Linking
Numbers L List Numbers Stored in Memory
MMH2834 Modem &F Load Factory Defaults
Store Modem &W Store Configuration & S-Register
Configurations Parameters
and Defaults Z Reset Modem
(Section J.1.4) V Result Code Terse/Verbose
&M Synchronous/Asynchronous Mode
Select
&X Synchronous Transmit Clock Select