Specifications

MA6

· You must have your RASExpress user name and password, which was assigned by the

LAN system administrator when the RASExpress server was installed.

· The RASExpress server and the client PC must be properly connected to a LAN with IPX

capability, and you must have access to a network version copy of a dial-in or dial-out

communications program with a MCSI-compatible interface.

Note: The INT14 that is used in Windows is not the same as a network INT14, and does not

connect to the gateway.

20. Turn on your client PC and log into your LAN.

21. Change to the subdirectory containing the MCSIWSN files, i.e., C:\MCSI.

22. Type mcsiwsn -a and press ENTER. This loads MCSIWSN and allows it to operate as an INT14

redirector. A message similar to the following appears:

Initializing, please wait...

INT14 Program is Resident.

23. Type logon and press ENTER. The following message appears:

Enter your user name.

Note: If you have more than one RASExpress server on your network and you are not listed

as a user on every RASExpress server, then you must type the following command: logon

ServerName\UserName.. E.g., logon server_1\user1.

24. Type user1 (or your valid RASExpress user name) and press ENTER. If a password has been

assigned, the following message appears. (If a password was not assigned, go to step 7.)

Enter your password.

25. Type user1 (or your valid RASExpress password) and press ENTER. Note that the password is

case-sensitive. The following message appears:

26. If the RASExpress server is the only remote access server on your LAN, then type coms14 -c

comn Inbound * * * (n is replaced by the number 1, 2, 3, or 4, which selects one of the COMS14

COM ports) or coms14 -c comn Outbound * * * and press ENTER (Inbound or Outbound must

be specified). This connects you to a line on the RASExpress server.

Note: If you have more than one remote access server on your network, see COMS14

Command Line Parameters on this page.

27. You are now connected to the RASExpress server and can run any INT14-compatible software.

Follow the softwares instructions to establish the softwares INT14 connection to the

RASExpress servers modem.

COMS14 Command Line Parameters

To list the COMS14 command line parameters, type coms14 ?. The following information appears.

Usage : coms14 -l [Server Name]

(for listing services)

: coms14 -c COM<n> <LineType> <SpecificName>

(for establishing a connection)

: coms14 -d COM<n>

(to disconnect)