Specifications

30 MA6
5 Disconnect the power and data cables from the back of the floppy disk drive.
6 Remove the four screws securing the floppy drive to the drive chassis.
7 Open the front door, remove floppy drive by sliding it out the front of the drive
chassis.
8 To install a new floppy drive, follow steps 1-7 in reverse.
Note
Before installing card cage, make sure power connectors from
power supply to midplane are fully connected.
CDROM Removal/Replacement
Table 4.6 CD ROM Removal/Replacement Procedure
Step Procedure
1 Remove the MiniArray
III
from rack enclosure following the steps in Table 4.1.
2 Remove the top cover from the MiniArray
III
by removing the seven cover mounting
screws located in the back of the MiniArray
III
. See figure 4-3.
3 Remove the chassis mounting screw from the card cage. See figure 4-4.
4 Being careful to maintain slack in the power cables, lift the card cage, including fan
housing, up and over so that it can rest along side the chassis.
5 Disconnect the power and data cables from the back of the CDROM drive.
6 Remove the four screws securing the CDROM drive to the drive chassis.
7 Open the front door and remove CDROM drive by sliding it out the front of the drive
chassis.
8 To install a new CDROM drive, follow steps 1-7 in reverse.
Note
Before installing card cage, make sure power connectors
from power supply to midplane are fully connected.
Power Supply Removal/Replacement
The card cage has to be removed in order to disconnect the power wiring before the power
supply can be removed.
Table 4.7 Power Supply Removal/Replacement Procedure
Step Procedure
1 Remove the MiniArray
III
from rack enclosure following the steps in Table 4.1.