Specifications

MA6

4 Being careful to maintain slack in the power cables, lift the card cage up and over so

that it can rest along side the chassis.

5 Remove the screw(s) that secures the ISI board(s) to the chasis at the back of the

MiniArray

III

6 Remove the ISI board(s) from the midplane.

7 To replace the ISI board(s), verify ISI board configuration; refer to the Installation

Instructions in the ISI section of this manual.

8 Install the new ISI card(s) by following steps 1-6 in reverse.

Hard Disk Drive Removal/Replacement

Table 4.4 Hard Drive Removal/Replacement Procedure

Step Procedure

1 Remove the MiniArray

III

from rack enclosure following the procedures in Table 4.1.

2 Remove the top cover from the MiniArray

III

by removing the seven cover mounting

screws located in the back of the MiniArray

III

. See figure 4-3.

Note

If you are simply adding a hard drive and not replacing the

existing hard drive, proceed to step 6.

3 Disconnect the power and data cables from the back of the hard disk drive.

4 Remove the two screws securing the hard drive to the drive chassis.

5 Remove hard drive by sliding it off of the drive chassis, towards the back of the unit.

6 To install a new hard drive, follow steps 1-5 in reverse.

Floppy Disk Drive Removal/Replacement

Table 4.5 Floppy Drive Removal/Replacement Procedure

Step Procedure

1 Remove the MiniArray

III

from rack enclosure following the steps in Table 4.1.

2 Remove the top cover from the MiniArray

III

by removing the seven cover mounting

screws located in the back of the MiniArray

III

. See figure 4-3.

3 Remove the chassis mounting screw from the card cage. See figure 4-4.

4 Being careful to maintain slack in the power cables, lift the card cage, including fan

housing, up and over so that it can rest along side the chassis.