Specifications

28 MA6
4 Remove the screw that secures the SBC board to the chassis at the back of the
MiniArray
III
.
5 Remove the SBC board from the midplane.
6 To replace the SBC board, verify SBC board configuration; refer to the Hardware
Configuration and Installation instructions in the SBC manual.
7 Install the new SBC board by following steps 1-5 in reverse.
8 If other boards are being installed, perform those procedures below now, and then
remount the MiniArray
III
in the enclosure. See Step 6 of Table 4.1.
Table 4.3Board Removal/Replacement Procedure (cont'd.)
Step Procedure
Removing NIC Board
1 Remove the MiniArray
III
from rack enclosure following the procedures in Table 4.1.
2 Remove the top cover from the MiniArray
III
by removing the seven cover mounting
screws located in the back of the MiniArray
III
. See figure 4-3.
3 Remove the screw that secures the NIC board to the chassis at the back of the
MiniArray
III
.
4 Remove the NIC board from the midplane.
5 To replace the NIC board, verify NIC configuration; refer to the Installation
Instructions in the appropriate NIC section of this manual.
6 Install the new NIC board by following steps 1-4 in reverse.
7 If other cards are being installed, perform those procedures below now, and then
remount the MiniArray
III
in the enclosure. See Step 6 of Table 4.1.
Removing ISI Boards
Note
If removing or replacing the single ISI board on the
left side (looking from the front) of the midplane, no card cage removal is
necessary. Ignore steps 3 through 5.
1 Remove the MiniArray
III
from rack enclosure following the procedures in Table 4.1.
2 Remove the top cover from the MiniArray
III
by removing the seven cover mounting
screws located in the back of the MiniArray
III
. See figure 4-3.
3 Remove the chasis mounting screw from the card cage. See figure 4-4.