Specifications

25
MA6
3 If LAN is connected to the MiniArray
III
, disconnect the 10BaseT cable at the NIC.
4 Disconnect the telephone cords (RJ11) from the ISI board(s).
Note
You may have ISI boards located in the left and
right halves of the card cage
Table 4.1 Cable Disconnection and Rack Enclosure Removal Procedure (cont'd.)
Caution
It is recommended that two people remove the MiniArray
III
from its rack enclosure
5 Remove the four rack enclosure mounting screws from the front of MiniArray
III
and
remove the MiniArray
III
from the rack enclosure. See Figure 4-2.
Handle
Enclosure
Mounting Holes
Fan Intake Vents
Single Processor
Data and Fax
Communications Server
Rack Enclosure
Mounting Screws
Fig. 4-2. Rack Enclosure Mounting Screws
6 To re-attach cables and re-mount the MiniArray
III
, follow steps 1-5 in reverse.
Card Cage Removal/Replacement
The following table describes the process for removing the card cage. Note that card cage
removal is not always necessary to remove or replace some components. If change will
only be made to the SBC side of the card cage, the card cage does not need to be removed.
Table 4.2 Card Cage Removal Procedure
Step Procedure
1 Remove the MiniArray
III
from rack enclosure following the procedures in Table 4.1.
2 Remove the top cover from the MiniArray
III
by removing the seven cover mounting
screws located in the back of the MiniArray
III
. The cover slides off the back of the
chassis.