Specifications

24 MA6
Introduction
This chapter provides procedures for removing and replacing the key hardware components
of the MiniArray
III
. Before removing or replacing any component, be sure to perform the
procedures in Table 4.1 which describes the process for disconnecting cables from the back
of the MiniArray
III
, and removing the MiniArray
III
from the rack enclosure. Your MiniArray
III
has been designed to make this process as efficient as possible, but if you experience
problems, contact Multi-Tech Technical Support, refer to chapter 6 of this section.
Disconnecting Cables and Removal from Enclosure
The following table describes the procedures for removing the MiniArray
III
from its rack
enclosure. These steps must be followed before any internal component can be removed or
replaced.
Warning
Anytime power has to be removed, turn off the Master Power
switch inside the front door.
Note
In order to make re-connection easier, be sure to note or label all cable connections
before disconnecting any cables from the MiniArray
III
.
Table 4.1 Cable Disconnection and Rack Enclosure Removal Procedure
Step Procedure
1 Remove the power cord from the back of the MiniArray
III
.
2 If connected, disconnect the video, COM 2, and keyboard cables from the back of
the SBC.
ISI Boards
120
Cover Mounting
Screws
Cover
NIC Board
COM 2
(DB15)
Printer Port
(DB25)
SBC Board
Power Supply
[( )]
•
Fig.4-1. Back Panel Connectors