Specifications

21
MA6
SBC
Backplane
6-Pin Circular Jack
(To External Keyboard)
Connect RS-232C
Serial Cable (female end)
here
15-Pin Video
Connector
(to External
Display Monitor)
120
Dumb Terminal
or
Auxiliary PC
RS-
232C
Cable
COM 1
DB9 male
Figure 3-2: Serial port on the MiniArray
III
B3. Power up the MiniArray
III
. The RASExpress Server Screen will appear.
Note: The server takes a few moments to load the RASExpress software and to
initialize the modems after it si turned on.Observe RAS software processing and
displaying .
B4. Turn on the terminal (or auxiliary PC) and press Enter.
B5. Select Quick Configuration of Server.
B6. Enable IP Remote Access.
Note: Error messages will appear and will indicate that the remote addresses of the
WAN ports are not on the same subnet. This is normal for the initial setup. Ignore
these messages.
B7. Type the IP Address for the MiniArray
III
RASExpress server.
B8. Type the IP Subnet Mask.
B9. Re-boot the MiniArray
III
.
B10. Using Telnet for access requires that a TCP/IP protocol stack be loaded on the client PC. Telnet
access is possible both by dialing in through the RASExpress server and, more commonly ,
through the LAN or Internet.