Specifications

15
MA6
ISI Board Cabling
Each ISI3334/8 board takes up one physical slot in the MiniArray
III
. Depending on your
configuration, you may have a total of up to four (4) cards (see figure 2-1). Attach the RJ11
line cords to the RJ11 line connectors on the ISI card(s) at the back of your MiniArray
III
, as
shown in Figure 2-3.
ISI3334/8 Board
120
RJ11 Line Jacks
[( )]
•
Fig. 2-3. ISI Board Connectors
Note
Any cables connected to the MiniArray
III
should
be shielded to reduce interference.
NIC Cabling
The EN-series EtherNet NIC is located as shown in Figure 2-4. The NIC connectors are of
theUTP (RJ45 connector) type.
Network
Interface
Card
120
RJ-45 UTP
Connector
100M
LINK
ACT
100M LINK ACT
Fig. 2-4. NIC Board Connector
Connect the appropriate network cable to the NIC in the MiniArray
III
. The various NIC
connectors are shown and defined in Appendix A.
Note
Any cables connected to the MiniArray
III
should
be shielded to reduce interference.