User guide

Quick Start Guide

3. Plug one end of your RJ45 ethernet cable into the MA100-

1M’s ethernet jack and the other end into your network

ethernet hub. This ethernet cable is not included with your

MA100-1M unit.

Caution: Before connecting to the Ethernet Network, make sure

that the network to which you are connecting the MA100-1M is

not a 192.168.2.x subnet. Because the MA100-1M’s factory

default IP address is 192.168.2.1, connecting it to a network that

has a different device at that same IP address would cause data

interference.

If it is a 192.168.2.x subnet, connect from the Administrative PC

to the MA100-1M using an RJ45 crossover cable until the

MA100-1M’s IP address has been configured. Thereafter,

connect the MA100-1M into the network with an ordinary RJ45

cable.

4. Plug one end of a phone cable into the telephone wall jack

and the other end into the LINE jack on the MA100-1M.