User guide

CommPlete 4000 Communications Server Overview 15
}
Shipped Configuration
120
100M LINK ACT
120
100M LINK ACT
Preferred
expansion
slots
120
100M LINK ACT
Installing expansion card here
requires removal of card cage.
Figure 2-3c. Convenience of using outer expansion slots before the inner slot
NIC Cabling
The 10/100Mb PCI EtherNet Network Interface Card is located as shown in Figure 2-4. The
NIC has a single RJ-45 connector and three LEDs.
Network
Interface
Card
120
RJ-45 UTP
Connector
100M
LINK
ACT
100M LINK ACT
Fig. 2-4. NIC Board Connectors
Connect the appropriate network cable to the NIC in the CommPlete 4000. The RJ-45 NIC
connector is shown and defined in Appendix A.
Note: Any cables connected to the CommPlete 4000 should be shielded to reduce interference.