Specifications

14 CommPlete 4000 Communications Server Quick Start Guide
Installing Your CommPlete 4000
SBC Board Cabling
The SBC board is located in the CommPlete 4000 as shown in Figure 2-1. The SBC board cabling may
involve connection to three back panel connectors (see Figure 2-2). The back panel connectors are:
 Video connector
 COM 1 connector
 Keyboard connector
SBC
Backplane
6-Pin Circular Jack
(To External Keyboard)
DB9 (male) Connector
(to COM 1 Serial Port)
15-Pin Video
Connector
(to External
Display Monitor)
120
100M LINK ACT
Fig. 2-2. SBC Backplane Connections
The right connector (COM 1) on the SBCs backplane typically accommodates a mouse or other
pointing device. The middle receptacle connects the video cable to a monitor. The left round
connector is for the keyboard.
Note: Any cables connected to the CommPlete 4000 should be shielded to reduce interference.
ISI Board Cabling
Each Intelligent Serial Interface card (ISI5634PCI/8, ISI4608PCI, or ISIHP-2S/2U) takes up one physical
slot in the CommPlete 4000. Depending on your configuration, you may have as many as four of these
cards (see Figure 2-1). Attach the line cords (RJ-12 for analog phone lines; RJ-45 for ISDN phone
lines) to the line connectors on the ISI card(s) at the back of your CommPlete 4000 as shown in Figure
2-3.
ISI5634PCI/8 Board
120
100M LINK ACT
RJ12 Line Jacks
Figure 2-3: ISI Board Connectors (ISI5634PCI/8 shown; other MultiModem ISI cards differ)
Note: Any cables connected to the CommPlete 4000 should be shielded to reduce interference.