User guide

89
Chapter 5 - AT Commands
%En Escape sequence options
@P3= Parity
@P4= Data bits
@P6= Stop bits
$MBn V.110 Network Rate
General Configuration Commands
@CONFIG Configuration Menu
En Command Mode Echo
%En Escape Sequence Options
&Fn Load Factory Profile
%Mn Management Mode
Qn Quiet Mode
Sr=n Set S-Register
Sr? Read S-Register
Vn Terse/Verbose ResultCodes
&Wn Store Active Profile
Xn Connect Messages
Z Restore parameters to current power-up profile
&Zn= Store Telephone Number
!Z=n Rate Adaptation Protocol
Digital (Data) Call Commands
A Answer
D Dial
H Hang up
In Display product information
O Return online
@Config Start ConfigMenu
Analog (Modem) Call Commands
*An Answer Analog Call
*Bn Send Analog Call Digit
*Dn Dial Analog Digit
*Hn Hang Up Analog Call
*!Hn Analog Call Hold-Off Time