User guide

Chapter 3 - Software Installation

3.14.4 Install Driver from Floppy Disk

Users starting with the untarred SCO5 driver on a floppy disk can begin the installation here.

1. Run the custom utility.

2. Select Software.

3. Select Install New.

4. Highlight driver file from local host and select Continue.

5. Select as the Media Device “Floppy Disk Drive.”

6. Select Continue.

7. Highlight “Multi-Tech ISA/PCI ...” and select Install.

8. Enter Y (yes) to continue installing the ISI driver.

9. As many as four ISI cards can be installed in the server. For further details see

MultiTech Installation

Script

step 1.

• If you are installing an ISIHP card, type 0 (zero).

• If you are installing an ISIHI card, type 1, 2, 3, or 4, based on the number of ISIHI cards you are

installing in your system. Type the base I/O address and the IRQ value for each card. Be sure that the

I/O address and the IRQ value match the values set in the DIP switch and jumper block on the ISIHI

card.

10. Type the number of pseudo-devices to be created. For further details see

MultiTech Installation Script

step 2.

• For the ISIHP-1S, type 4.

• For the ISIHP2S/2U/4SD and ISIHI-2S/2U, type 8.

• For ISIHP-4S/4U, type 16.

11. Type Y (yes) to accept the prefix for tty ports. For further details see

MultiTech Installation Script

step 3.

12. Type Y (yes) to confirm the selection. For further details see

MultiTech Installation Script

step 4.

13. After the driver is installed, press ENTER to continue. For further details see

MultiTech Installation Script

step 4(last paragraph) and step 5.

14. Exit the custom utility. For further details see

MultiTech Installation Script

step 6.

15. Remove the floppy disk and reboot your computer. For further details see

MultiTech Installation Script

step 7.