User guide

42
Chapter 3 - Software Installation
3.12 Terminal Adapter AT Commands
You can configure the terminal adapters using AT commands just as you would configure an analog modem.
Use this method if you prefer to work with AT commands or if you have a special requirement not addressed
by either of the configuration utilities.
1. Start a data communication program and select the TA COM ports to be configured.
2. Referring to records made for your system, enter AT commands in the terminal window of the data
communications program.
3. When you finish, use the &W command to save your new configuration and to select it to load
automatically when the ISIHP is turned on.
4. Close the data communications program. For more information, see the chapter "AT Commands and S-
Registers" in this manual.
3.13 NetWare Driver Installation
Multi-Tech Systems provides AIO drivers for the ISIHx cards, so they can function with Novell compatible
asynchronous applications (e.g., NetWare Connect). The AIO driver is simply an NLM (NetWare Loadable
Module) that runs on the file server. Drivers must be loaded on the file server where the board is installed.
Drivers can be loaded from the file server’s console prompt or incorporated for autoloading in the
AUTOEXEC.NCF file.
The file AIOMTS.MDC contains Novell (version 3.12 and higher) initialization strings for ISI products not
previously listed for use with BorderManager and Netware Connect. The file AIOMTS.MDC is included on the
ISI Product Family CD. To benefit from the AIOMTS.MDC file, you must copy it from the CD to the appropriate
directory on your computer.
• To use AIOMTS.MDC under Border Manager, RAS, NIAS in 4.2 or 5.x copy AIOMTS.MDC to your
System directory.
• To use AIOMTS.MDC under Novell NetWare 3.x, 4.1, 4.11 with NetWare Connect 2.0.28 or higher
copy AIOMTS.MDC to your System and System/AIO directory.
• To install the Multi-Tech AIO driver, copy the file AIOISIX.NLM to the system directory of the file server
from a workstation on the network. Use
COPY E:\SERVCARD\DRIVERS\NOVELL\AIOSIX.NLM
F:\SYSTEM
• If you have downloaded the ISI driver from the MultiTech web site onto a diskette, use COPY
A:\NOVELL\AIOISIX.NLM F:\SYSTEM
• To load the driver, go to the system or PC console (where the ISI card is installed) and enter at the
prompt LOAD AIOISIX [port=W] [interrupt=X] [name=Y] [note=Z]
• For PCI-bus cards (ISIHP models) Netware will set up the interrupt (IRQ) and I/O address
automatically.
• To install the ISI card scripts, copy aiomdms.mdc to F:\SYSTEM\AIO\DIRECTORY . Click Yes to
overwrite the existing aiomdms.mdc file.