User guide

41
Chapter 3 - Software Installation
3.11 ConfigMenu Configuration Utility
The ConfigMenu configuration utility can be used as another means of configuring the TA. ConfigMenu is
installed in the TAs as part of the firmware.
1. Start a data communication program and select the COM port where the TA is connected.
2. In the communication program dialog box, type "AT@CONFIG" and press ENTER. ConfigMenu’s Main
Menu appears (see screen below).
3. To select menu item, type its number and press ENTER. A submenu then appears where you can make
selections. At the lowest level, you can change a configuration option by selecting a number or typing a
value and pressing ENTER.
4. When you finish, close ConfigMenu by typing x and pressing ENTER.
5. You will be prompted to decide whether to save the configuration when you exit the ConfigMenu program.
Type y to have ConfigMenu automatically save the configuration.
3.11.1 ConfigMenu Menus
Network Configuration Configures network parameters such as switch type, data and voice TEIs, and
data and voice MSNs. When you finish, select Save Network Configuration to
save your work.
Call Control Configuration Changes how the TA originates and answers calls. Options include Auto
Answer, Rings to Answer, Dialing Method, and Persistent DTR Dialing.
Data Protocol Changes rate adaption protocol used by the TA.
Stored Numbers Stores up to ten phone numbers ( maximum of 20 characters each). Stored
number 0 is the phone number that will be dialed if persistent DTR dialing is
enabled.
Port Control Configuration Configures TA’s serial port, including how TA responds to control signals on
the serial interface.
Help Menu Provides assistance in navigating through the TA menu system or viewing the
firmware version numbers of the ISIHI or ISIHP card.