User guide

40
Chapter 3 - Software Installation
14. The Data Protocol Setup dialog box appears. Referring to your network configuration notes, enter the
appropriate information; then click Next.
15. In the Save Configuration dialog box, enter a name to store the configuration. Then click Next.
16. To load the configuration, click Next in the Load Configuration dialog box.
17. Then click Finish in the Configured dialog box.
18. The first TA now is configured. Click Back to return to the Configuration dialog box and repeat steps 4
through 9 to configure the remaining TA(s). If you install multiple ISIHI or ISIHP cards in the same PC,
you must configure two TAs per 2S or 2U card installed or four TAs per 4S, 4U, or 4SD card. For the
ISIHP-1S, you configure only one TA. For example, if you install four ISIHP-2S/2U cards in one PC, you
have to configure eight TAs (two per card).
19. After all TAs are configured, close the ISDN TA Configuration utility.