User guide

39
Chapter 3 - Software Installation
3.10 ISDN TA Configuration Utility
1. Make sure Windows NT Remote Access Service (RAS), or any other application that is using the modem,
is shut down. To shut down RAS, click
Start | Programs | Administrative Tools (Common) . Then click
Remote Access Admin and click Server, which will indicate whether or not RAS is running. If it is running,
click Stop Remote Access Service.
2. Insert the Config Utility CD into the drive.
3. From the main desktop of your PC, select
Start | Settings | Control Panel . Click on the Add/Remove
Programs icon. Click Install.
4. The dialog box Install Program CD-ROM appears. Click Next. The Run Installation Program dialog box
appears. Click Finish.
5. The Welcome dialog box for the ISDN TA Configuration Utility Setup program appears. Click Next.
6. The Choose Destination Location dialog box appears.
7. The Setup dialog box appears.
8. The Information dialog box appears. Click OK.
9. Click Start, Programs, and then the ISDN TA Configuration Utility icon.
10. The Welcome dialog box appears. Click Next.
11. The Searching for TA dialog box appears. Click Next. The next dialog box specifies the TA that has been
identified.
12. The Configuration dialog box appears. If you have questions about choices, click Help. After entering
information in each dialog box, click Next.
13. The SPID dialog box appears (North America only). Referring to your network configuration notes, enter
the appropriate information; then click Next.