User guide

30
Chapter 3 - Software Installation
3.5 Remove ISIHx Driver (Windows 2000)
1. Go to Start | Settings | Control Panel.
2. Click on Add/Remove Hardware. Click Next.
3. Click on “Uninstall/Unplug a device” and click Next.
4. In the subsequent screen, click on “Uninstall a device” and click Next.
5. At the Add/Remove Hardware Wizard screen, highlight the ISI driver file for the specific server card that
you intend to remove. Click Next.
6. When you are asked to confirm removal, click on the Yes radio button and click Next.
7. Click Finish. You can remove the driver for only one ISIHx card at a time.
3.6 ISIHx Software Installation Procedure for
Windows NT 3.51/4.0
1. Turn off the PC.
2. The ISIHx card must be installed in an expansion slot in the PC. If not, follow the PC manufacturer's
instructions concerning installation of expansion cards.
• For ISIHP cards. Install the ISIHP card in an available PCI expansion slot in the computer.
• For ISIHI cards. Install the ISIHI card in an available ISA expansion slot in the computer. Set the Base
I/O Address and the Interrupt Request (IRQ) values per the table below. The I/O Address DIP Switch is
on the end plate of the ISIHI; the IRQ Jumper Block is on the component side of the circuit card, lower
middle area.
Note: Observe standard precautions regarding electrostatic discharge (ESD) when handling the ISIHx board.
During installation, handle the ISIHx circuit card by its edges and keep one hand in contact with the PC
chassis.
Table 5: Recommended Base I/O Address and IRQ Values
ISIHI-2S/2U Base I/O IRQ
Address
Initial 8 port board 210h 10
First 8 port upgrade 220h 11
Second 8 port upgrade 230h 12
Third 8 port upgrade 240h 15
3. Turn on the PC and start Windows NT4.0.
4. Insert the driver CD-ROM into the CD-ROM drive.
5. Click Start | Settings | Control Panel | Network | Adapters . Then click Add.
6. The Select Network Adapter dialog box appears. Click Have Disk.
7. The Insert Disk dialog box appears. Type or browse for the path (file directory location) of the Windows
NT driver (for example,
E:\SERVCARD\DRIVERS\WINNT\SETUP.EXE ). Click OK.