User guide

Chapter 3 - Software Installation

3.3 Installing ISIHP Software for Win 2000

Note: A series of ‘installation wizard’ screens will appear repeatedly during this procedure (step 12). This is

not an error. Do not discontinue the procedure when the ‘installation wizard’ screens repeatedly appear.

1. Shut down Windows 2000 and turn off the PC.

2. Install the ISIHP can in an available PCI expansion slot in the PC. Follow the PC manufacturer's

instructions concerning installation of expansion cards.

Note: Observe standard precautions regarding electrostatic discharge (ESD) when handling the ISIHI board.

During installation, handle the ISIHI circuit card by its edges and keep one hand in contact with the PC

chassis.

3. Turn on the PC and start Windows 2000.

4. Insert the ISI driver CD-ROM into the CD-ROM drive. Windows 2000 will detect the ISIHP card. The

Found New Hardware Wizard- Welcome screen will appear. Click Next.

5. The Install Hardware Device Drivers screen appears. Select "Search for a suitable driver ..." and click

Next.

6. The Locate Driver Files screen appears (Windows 2000 is seeking the driver for the ISIHP card). Select

“CD-ROM drives” and click Next.

7. The Driver File Search Results screen appears. Click Next. A progress screen will appear briefly while

files are being copied.

8. A completion screen will appear. Click Finish.

9. Immediately after the ISI driver installation has been completed, another Found New Hardware screen will

appear briefly indicating that the “MultiTech ISI Port” has been detected.

10. A second sequence of ‘installation wizard’ screens appears. This sequence of screens deals with the

setting up of ISI ports. The first screen in this sequence is the Found New Hardware Wizard -- Welcome

screen.

11. The Found New Hardware -- MultiTech ISI Port screen will appear once for each modem and terminal

adapter on the ISIHP card:

• 16 times for the ISIHP-4S/4U/4SD (only 8 devices can be installed on the 4SD)

• 8 times for the ISIHP-2S/2U/1S (only 4 devices can be installed for the ISIHP-1S)

12. The Install Hardware Device Drivers screen appears. Select “Search for a suitable driver ... “. Click Next.

13. The Locate Driver Files screen appears (Windows 2000 is seeking the ISI Port device driver). Select “CD-

ROM drives” and click Next.

14. The Driver Files Search Results screen will indicate that the “isiport.inf” file has been found on the CD-

ROM. Click Next.

15. A completion screen will appear. It will indicate that the first “MultiTech ISI Port” has been set up

successfully. Click Finish.

The Found New Hardware -- MultiTech ISI Port screen will appear many times after the ISI driver has

been located. On this screen, the messages “Found New Hardware” and “Installing ...” will appear

alternately. Repetition of these screen sequences is normal and is not an error.

16. Driver installation for the ISIHP card is complete.