Specifications

22
ISI4608 Quick Start Guide
ISI4608 Software Installation Procedure
for Windows 95/98/ME
1. Turn off the PC.
2. The ISI4608 card must be installed in an ISA-type expansion slot
in the PC. If not, install the ISI4608 card in an available ISA
expansion slot following the PC manufacturer's instructions
concerning installation of expansion cards. Observe standard
precautions regarding electro-static discharge (ESD) when handling
the ISI4608 board (the board should be kept in its shipping bag until
used). During installation, handle the ISI4608 circuit card by its
edges and keep one hand in contact with the PC chassis.
Set the Base I/O Address and the Interrupt Request (IRQ) values
per the table below:
Recommended Base I/O Address and IRQ Values
ISI4608 Base I/O Address IRQ
Initial 8 port board 210h 10
First 8 port upgrade 220h 11
Second 8 port upgrade 230h 12
Third 8 port upgrade 240h 15
The I/O Address DIP Switch and the IRQ Jumper Block are at the
top middle of the ISI4608 circuit board and on the component side.
3. Turn on the PC and start Windows 95/98/ME.
4. Insert MultiTech ISI driver CD-ROM into the CD-ROM drive. (If
drivers were downloaded from the MultiTech web site and placed
on diskette, insert diskette into floppy drive now.)
5. (Follow either 5A or 5B, but not both.)
A. From Windows Explorer, open the 95-98-ME directory on the
CD-ROM or floppy drive that contains the ISI driver file (for
example, E:\SERVCARD\DRIVERS\95-98-ME\). Highlight the file
setup.exe.
B. From the Start menu, go to Run. Browse to the path of the
95-98-ME directory.