Specifications

20
ISI4608 Quick Start Guide
ISI4608 Software Installation Procedure for
Windows NT 3.51/4.0
1. Turn off the PC.
2. The ISI4608 card must be installed in an ISA-type expansion slot
in the PC. If not, follow the PC manufacturer's instructions
concerning installation of expansion cards. Observe standard
precautions regarding electro-static discharge (ESD) when handling
the ISI4608 board (the board should be kept in its shipping bag until
used). During installation, handle the ISI4608 circuit card by its
edges and keep one hand in contact with the PC chassis.
Recommended Base I/O Address and IRQ Values
ISI4608 Base I/O Address IRQ
Initial 8 port board 210h 10
First 8 port upgrade 220h 11
Second 8 port upgrade 230h 12
Third 8 port upgrade 240h 15
The I/O Address DIP Switch and the IRQ Jumper Block are at the
top middle of the ISI4608 circuit board and on the component side.
3. Turn on the PC and start Windows NT4.0.
4. Insert the driver CD-ROM into the CD-ROM drive. (If drivers
were obtained from MultiTech web site and stored on diskette, place
diskette into floppy drive now.)
5. Click Start | Settings | Control Panel | Network | Adapters. Then
click Add.
6. The Select Network Adapter dialog box appears. Click Have
Disk.
7. The Insert Disk dialog box appears. Type or browse for the path
(file directory location) of the Windows NT driver (for example,
E:\SERVCARD\DRIVERS\WINNT\SETUP.EXE). Click OK.