Specifications

17
Chapter 3 - Driver Installation
The I/O Address DIP Switch and the IRQ Jumper Block are at the
top middle of the ISI4608 circuit board and on the component side.
3. Turn on the PC and start Windows 2000.
4. Insert the ISI driver CD-ROM into the CD-ROM drive in the computer
(in cases where the driver files have been downloaded from the
MultiTech web site and copied onto diskette, insert the diskette into
the floppy drive now).
5. Go to Start | Settings | Control Panel | Add/Remove Hardware.
Click Next.
6. At the Choose a Hardware Task screen, select "Add/Troubleshoot a
device."
Click Next.
7. At the Choose a Hardware Device screen, select "Add a new device."
Click Next.
8. At the Find New Hardware screen, select "No, I want to select the
hardware from a list."
Click Next.
9. At the Hardware Type screen, select "Multi-port serial adapters."
Click Next.
10. At the Select a Device Driver screen, click on Have Disk.
11. At the Install from Disk screen, enter the pathof the driver files (i.e.,
the file directory location, in most cases on CD-ROM).
Click OK.
12. In the Models list, highlight "Multi-Tech ISI4608-ISA 8 Port Serial
Card."
A comment screen appears indicating that the Base I/O Address and
IRQ must be specified for the ISI4608 card.
Click OK.
13. The Add New Hardware Wizard Properties screen appears.
A. In the Resource Settings field, select "Input/Output Range" and
click on Change Setting. The Edit Input/Output Range screen
appears.