Specifications

14
ISI4608 Quick Start Guide
Table 2-2 (cont’d)
Step Procedure
Figure 2-2. Octopus Cable
8 Turn power on to the computer and refer to the manual that
was provided with the software you will be using with the
ISI4608 in order to perform software installation procedures.
Note: If the ISI4608 card is being used as an expansion card
(Remote Node--model #RNI08) for the
MultiComRN Gateway , then you must reconfigure the
gateway software, using the RASCON.EXE program. You
will need to add the card's settings to the Board Information
entry and assign access rights to each user under the User
Information entry. See Chapter Three of the
MultiComRN Gateway Owner's manual for server
configuration.