Specifications

ISI4608 Quick Start Guide

Hardware Installation Procedure

Perform the procedures in Table 2-2 to install the ISI4608 card(s) in

your PC-ISA bus computer. The installation procedures include

setting the I/O address switch block and the IRQ jumper. This section

may be skipped if the defaults: I/O Address 210 Hex and IRQ 10 are

the values you have selected. However, if you are installing multiple

cards, step 4a of Table 2-2 describes how to configure your card(s).

Table 2-2

ISI4608 Installation Procedure

Step Procedure

1 Make sure your computer and any peripheral equipment

connected to it are turned off. Failure to do so may damage

both your ISI card(s) and your PC. The ISI4608 may be

installed in a PC-AT, 386, 486, or Pentium equivalent ISA-

bus computer.

2 Remove the cover of your computer as instructed in your

computer’s documentation.

3 Locate the unused slot(s) which you will be using for your

ISI4608 card(s), and remove the slot cover(s) per the

instructions in your computer’s documentation.

4 Check the settings of the I/O address switch and the IRQ

jumper to ensure that they are set properly for your

installation.

Figure 2-1. ISI4608 Board Components