User guide

Chapter 2 - Installation
29
- Make sure Device is pointed to the floppy disk.
- Make sure that the Type is cpio.
- Select Continue.
5. To verify that the files have been copied onto the floppy disk, use these commands:
# scosh
- Select Manager.
- Select Archive.
- Select List.
- Make sure Device is pointed to the floppy disk.
- Select Continue.
To install driver from floppy disk
(Users starting with the untarred SCO5 driver on a floppy disk can begin the installation here).
1. Run the custom utility.
2. Select Software.
3. Select Install New.
4 Highlight driver file from local host and select Continue.
5. Select as the Media Device Floppy Disk Drive.
6. Select Continue.
7. Highlight Multi-Tech ISA/PCI ... and select Install.
8. Enter Y (yes) to continue installing the ISI driver.
9. As many as four ISI cards can be installed in the server. Type 1, 2, 3, or 4, based on the number of ISI3334
cards you are installing in your system. Type the base I/O address and the IRQ value for each card. Be sure that
the I/O address and the IRQ value match the values set in the DIP switch and jumper block on the ISI3334 card.
For further details see MultiTech Installation Script step 1.
10. Type the number of pseudo-devices to be created.
For the ISI3334-4, type 4.
For the ISI3334-8, type 8.
For further details see MultiTech Installation Script step 2.
11. Type Y (yes) to accept the prefix for tty ports. For further details see MultiTech Installation Script step 3.
12. Type Y (yes) to confirm the selection. For further details see MultiTech Installation Script step 4.
13. After the driver is installed, press <Enter> to continue. For further details see MultiTech Installation Script step
4(last paragraph) and step 5.
14. Exit the custom utility. For further details see MultiTech Installation Script step 6.
15. Remove the floppy disk and reboot your computer. For further details see MultiTech Installation Script step 7.