User guide

ISI3334-4/8 Quick Start Guide
22
14. Click on Set Configuration Manually.
15. Set the "Input/Output Range" to match the Base I/O Setting that you specified on the hardware DIP switch in Step 2
above. Set the "Interrupt Request" to match the IRQ setting you specified on the hardware jumper block in Step 2 above.
To alter these parameters, click on the Change Setting button.
16. When editing of IRQs and Base I/O Address settings is complete, click OK. Then click OK at the Resources screen.
The System Settings Change screen appears and prompts you to restart your computer. Click Ye s.
17. When prompted about re-starting your computer, click Ye s .
18. When the computer is restarted, the software installation will be complete.