User guide

ISI3334-4/8 Quick Start Guide
16
ISI3334 for Windows 2000: Installing ISI Management Software (server OSs
only)
If you are using a Windows 2000 Server operating system ("Server" or "Advanced Server"), you must decide
whether you want to use the MultiTech ISI Management Software in conjunction with your ISI3334 board. The ISI
Management Software is shipped with the ISI card and, alternatively, can be downloaded from the MultiTech web
site (www.multitech.com).
1. Turn on your computer and start Windows 2000.
2. Insert the CD-ROM or diskette containing the ISI Management Software into your CD-ROM or floppy drive.
3. Go to Start | Run. In the Run window, enter the file path at which the ISI Management Software setup program is located;
for example D:\MANAGEMENT\SETUP.EXE.
Click OK.
4. The ISI Management setup screen appears. At the Welcome screen, click Next.
5. A progress screen appears while files are copied. If the Error Creating Virtual WWW Server message appears, it may
indicate that there was an attempt to install the ISI Management Software on a client version of Windows 2000. (The ISI
Management Software can be installed only in the Windows 2000 Server and Windows 2000 Advanced Server operating
systems.)
6. A completion screen appears. Select "Yes, I want to restart my computer now" and click Finish.
After the computer has restarted, the installation of the driver and of the ISI Management Software will be complete.
##?## begin insert ##?##
Remove ISI3334 Driver (Windows 2000)
1. Go to Start | Settings | Control Panel.
2. Click on Add/Remove Hardware. Click Next.
3. Click on Uninstall/Unplug a device and click Next.
4. In the subsequent screen, click on Uninstall a device and click Next.
5. At the Add/Remove Hardware WIzard screen, highlight the ISI driver file for the specific server card that you intend to
remove. Click Next.
6. When you are asked to confirm removal, click on the Yes radio button and click Next.
7. Click Finish. You can remove the driver for only one ISI3334 card at a time.
ISI3334 Software Installation Procedure for Windows NT 3.51/4.0
1. Turn off the PC.
2. The ISI3334 card must be installed in an ISA expansion slot in the PC. If it is not already installed, install the ISI3334
card according to the PC manufacturer's instructions. Observe standard precautions regarding electro-static discharge
(ESD) when handling the ISI3334 board (the board should be kept in its shipping bag until used). During installation,
handle the ISI3334 circuit card by its edges and keep one hand in contact with the PC chassis. Set the Base I/O Address
and the Interrupt Request (IRQ) values per the table below:
Recommended Base I/O Address and IRQ Values
ISI3334 Base I/O Address IRQ
Initial 8 port board 210h 10
First 8 port upgrade 220h 11
Second 8 port upgrade 230h 12
Third 8 port upgrade 240h 15
The I/O Address DIP Switch and the IRQ Jumper Block are located in the corner of the card that lies diagonally across from
the ISA bus.