Specifications

ISI3334/4 Hardware/Driver Installation Manual

2.2 Remote Configuration

The Remote Configuration feature is a network management tool

that allows you to configure modems remotely. This means you

could configure modems anywhere in your network from one

location without having to visit the sites or rely on remote users to

follow your instructions. With Remote Configuration, which is

protected by two level security, you can downline load new

parameters, program new V.42 capabilities and implement new

features. Remote Configuration also makes troubleshooting a

remote location a lot easier.

The way Remote Configuration works is that S-Register S13 has

been set-up to contain the special Remote Configuration escape

code. When calling a Remote Configuration equipped modem, you

enter the proper Remote Escape code to enable entering your Set-

up Password. After entering it, you can then execute AT commands

as if you were connected locally. If you set S-Register S13 to zero,

Remote Configuration is disabled.

2.2.1 Remote Configuration Procedures

The procedures for using the Remote Configuration features are the

same whether or not a call originates from the remote modem. Once

the modem is on-line, perform the procedures in Table 2-1.

Table 2-1

Remote Configuration Operation Procedures

Step Procedure

1. Remote Escape Configuration requires %%%<CR> to be sent if

the default value in S-Register S13 has not been changed. The

modem responds with:

1. - DATA Mode

2. - COMMAND Mode

2. You then select 1 or 2. With 1, the modem goes back into data

mode and with 2, the modem responds with the following:

Password>