Specifications

Chapter 2 - AT Commands, S-Registers and Result Codes
21
COMMAND: O
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Exit Command Mode and go into On-Line
Mode.
COMMAND: P
VALUES: n/a
DEFAULT: Tone Dial
DESCRIPTION: Modem will pulse-dial numbers following the
P.
COMMAND: &P n
VALUES: n = 0 or 1
DEFAULT: &P1
DESCRIPTION: &P0 selects 60-40 pulse ratio.
&P1 selects 67-33 pulse ratio.
COMMAND: #P n
VALUES: n = 0, 1 or 2
DEFAULT: #P2
DESCRIPTION: #P0 selects no parity.
#P1 selects odd parity.
#P2 selects even parity.
COMMAND: Q n
VALUES: n = 0, 1 or 2
DEFAULT: Q0
DESCRIPTION: Q0 means Result Codes sent.
Q1 means Result Codes will be suppressed
(quiet).
Q2 means Dumb Answer Mode.
COMMAND: &Q n
VALUES: n = 0 or 1
DEFAULT: &Q0
DESCRIPTION: &Q0 selects Multi-Tech command set.
&Q1 selects AT command set.