Specifications

Chapter 2 - AT Commands, S-Registers and Result Codes
17
&E11 selects Normal Mode flow control on.
&E12 selects Pacing off.
&E13 selects Pacing on.
&E14 selects data compression disabled.
&E15 selects data compression enabled.
COMMAND: %E n
VALUES: n=0 thru 5
DEFAULT: %E1
DESCRIPTION: %E0 = Modem Won’t Escape.
%E1 = +++ Method (default setting).
%E2 = Break Method.
%E3 = Either +++ or Break Method.
%E4 = No "OK" Response to +++
%E5 = "OK" Response to +++
COMMAND: #F n
VALUES: n = 0 thru 2
DEFAULT: #F2
DESCRIPTION: #F0 means no fallback when on-line.
#F1 means fallback from 33600 to 4800 bps
when on-line (increments of 2400 bps).
#F2 means fallback to 4800 bps from 33.6K
bps/fall forward if line improves (increments
of 2400 bps).
COMMAND: &F n
VALUES: n = 0, 8 or 9
DEFAULT: &F8
DESCRIPTION: &F loads factory default values from ROM.
&F8 reads factory default values when &F is
issued.
&F9 reads parameters stored in nonvolatile
memory when &F is issued.