User guide

46 CommPlete Series 4000 Server SBC, Model IPC-551
Award BIOS Setup
as a Primary Slave drive and be designated as Drive D. The type
and mode settings for the primary master and the primary slave
drives should, in most cases, be AUTO. The default configuration
state for the secondary master/slave is DISABLED.
When this field of the Standard CMOS Setup screen is set to AUTO,
the IPC-551 will automatically detect the hard drive(s) in the system.
The IPC-551 can auto-detect 45 specific drive types ( designated 1-45
in this field).
The drive type can also be entered manually. If entered manually, the
drive in use must match the type entered in this field. If the drive being
used is not of the type specified in this field, it will not work properly
in the CommPlete 4000. For drives not on the list of 45 types, a user-
defined drive can also be specified in this field (as type User).
When User is selected for this field, the operator must specify the
parameters of the hard drive (number of cylinders, heads, etc.). This
information should be provided in the documentation for the hard
drive unit (this information is often specified on the exterior of the hard
drive unit, as well).
Note: If your IPC-551 has trouble detecting your hard drive when the
Type field in the Standard CMOS Setup screen is set to AUTO, then you
should enable the IDE HDD Auto Detection function in the CMOS Setup
Utility screen. If the hard drive is still not detected, designate the Type as
User and enter the hard-drive values into the Standard CMOS Setup
screen
If the controller of the hard-disk drive interface is ESDI, the selection
shall be
Type 1.
If the controller of the hard-disk drive interface is SCSI, the selection
shall be None
If the controller of the hard-disk drive interface is CD-ROM, the
selection shall be None