User guide

Software Configuration
CommPlete 4000 Server SBC, Model IPC-551 35
5. Installing the VGA driver into OS/2 Warp Operating System
(A) Preliminary Steps:
 OS/2 DOS Support must be installed.
 If you previously installed SVGA support, you must reset
the system to VGA mode. VGA is the default video mode.
Enable VGA when OS/2 is to be installed.
 To restore VGA mode, use SELECTIVE INSTALL. Specify
VGA as the PRIMARY DISPLAY. For more information on this
procedure, see the section on Changing Display Adapter
Support in the OS/2 Users Guide.
(B) Start Driver installation from Utility Disk#2
(B1) Open an OS/2 full screen or windowed session.
(B2) Insert Utility Disk#2 into the floppy disk drive. Utility
Disk#2 contains the 65550 Display Driver.
(B3) At the OS/2 command prompt , type the following
commands to copy the files to the OS/2 drive:
Type A: and press ENTER to make this the default drive.
Type Setup A: C: and press ENTER.
When the setup program has finished running, you must
shut down and then restart the computer in order for the
change to take effect.
(B4) After restarting the system, open the OS/2 System folder.
(B5) Open the System Setup folder.
(B6) Open the Display Driver Install Object.
(B7) When the Display Driver Install window appears, select
PRIMARY DISPLAY, and click OK.
(B8) When the Primary Display Driver List window appears,
select Chips and Technologies 65550/554 from the list of
Adapter Types.