User`s manual

Chapter 3- BIOS Setup
Multi-Tech Systems, Inc. Single Board Computer IAC-F696 User’s Guide (S000349A) 34
Integrated Peripherals
When you select the INTEGRATED PERIPHERIALS on the main program, the screen display will
appears as:
Integrated Peripherals Setup Screen
Phoenix - Award BIOS CMOS Setup Utility
Integrated Peripherals
Item Help
Menu Level f
On-Chip Primary PCI IDE
On-Chip Secondary PCI
IDE
Init Display First
USB Controller
USB Keyboard Support
USB Mouse Support
AC97 Audio
Onboard Lan Boot ROM
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART 2 Mode Select
UART 2 Duplex Mode
Onboard Parallel Port 1
Onboard Parallel Mode
ECP Mode Use DMA
Parallel Port EPP Type
[Enabled]
[Enabled]
[Add-On Card]
[Enabled]
[Disabled]
[Disabled]
[Auto]
[Disabled]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
Half
[378/IRQ7]
[SPP]
[3]
[Epp1.9]
Ç È Æ ³ Move Enter: Select +/-/PU/PD: Value F10: Save Esc: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
The following explains the options for each of the features as listed in the above menu:
On-Chip Primary PCI IDE: The chipset contains a PCI IDE interface with support for two IDE channels.
Select Enabled to activate the primary IDE interface. Select Disabled to deactivate this interface. The settings
are Enabled and Disabled.
On-Chip Secondary PCI IDE: The chipset contains a PCI IDE interface with support for two IDE channels.
Select Enabled to activate the secondary IDE interface. Select Disabled to deactivate this interface. The
settings are Enabled and Disabled.
Init Display First: This item allows you to decide to active whether PCI Slot of VGA card or AGP first. The
settings are Add-On Card and Onboard AGP.
USB Controller: Select Enabled if your system contains a Universal Serial Bus (USB) controller and you
have USB peripherals
USB Keyboard Support: Set this option to Enabled or Disabled the USB keyboard support. The default
setting is Disabled.
USB Mouse Support: Set this option to Enabled or Disabled the USB mouse support. The default setting is
Disabled.
AC97 Audio: This option sets the AC97 Audio. The settings are Auto and Disabled.
Onboard Lan Boot ROM: Unless you intend to boot using PXE Enabled/Disabled.