User`s manual

Chapter 3- BIOS Setup
Multi-Tech Systems, Inc. Single Board Computer IAC-F696 User’s Guide (S000349A) 29
Here is a brief explanation of drive specifications:
• Access Mode: The settings are Auto, CHS, Large, LBA.
• Cylinder: Number of cylinders
• Head: Number of heads
• Precomp: Write precom
• Landing Zone: Landing Zone
• Sector: Number of sectors
Drive A and Drive B: Select the correct specifications for the diskette drive(s) installed in the
computer.
None No diskette drive installed
360K, 5.25 in 5-1/4 inch PC-type standard drive; 360 kilobyte capacity
1.2M, 5.25 in 5-1/4 inch AT-type high-density drive; 1.2 megabyte capacity
720K, 3.5 in 3-1/2 inch double-sided drive; 720 kilobyte capacity
1.44M, 3.5 in 3-1/2 inch double-sided drive; 1.44 megabyte capacity
2.88M, 3.5 in 3-1/2 inch double-sided drive; 2.88 megabyte capacity
Note: 1. Not Installed could be used as an option for diskless workstations.
2. Highlight the listing after each drive name and select the appropriate entry.
Halt On: During the power-on-self-test (POST), the computer stops if the BIOS detect a hardware error.
You can tell the BIOS to ignore certain errors POST and continue the boot-up process. These are the
selections:
No errors Whenever the BIOS detects a non-fatal error the system will not be stopped
and you will be prompted
All errors The system boot will be stopped for any error that may be detected.
All, But Keyboard The system boot will not stop for a keyboard error; it will stop for all other
errors.
All, But Diskette The system boot will not stop for a disk error; it will stop for all other errors.
All, But Disk/Key The system boot will not stop for a keyboard or disk error; it will stop for all
other errors.