User`s manual

Chapter 3- BIOS Setup
Multi-Tech Systems, Inc. Single Board Computer IAC-F696 User’s Guide (S000349A) 27
CMOS Setup Utility
To access the AWARD BIOS SETUP program, press the <DEL> key. The screen display will
appears as shown below:
Main Program Screen
Phoenix - Award BIOS CMOS Setup Utility
Standard CMOS Features PC Health Status
Advanced BIOS Features Load Optimized Defaults
Advanced Chipset Features Set Supervisor Password
Integrated Peripherals Set User Password
Power Management Setup Save & Exit Setup
PnP/PCI Configurations Exit Without Saving
Esc : Quit
Ç È
Æ ³
: Select Item
F10 : Save & Exit Setup
Time, Date, Hard Disk Type...
This screen provides access to the utility‘s various functions.
Listed below is explanation of the keys displayed at the bottom of the screen:
<ESC> : Exit the utility.
<Ç È Æ Å>: Use arrow keys Ç È Æ Å to move cursor to your desired selection.
<F1> : General Help
<F10> : Saves all changes made to Setup and exits program.
The following explains the options for each of the features as listed in the above menu:
Standard CMOS Features: Use this menu for basic system configurations.
Advanced BIOS Features: Use this menu to set the Advanced Features available on your system.
Advanced Chipset Features: Use this menu to change the values in the chipset registers and
optimize your system’s performance.
Integrated Peripherals: Use this menu to specify your settings for integrated peripherals.
Power Management Setup: Use this Menu to specify your settings for power management.
PnP/PCI Configurations: This entry appears if your system supports PnP/PCI.
PC Health Status: This entry shows your PC health status, if Hardware Monitor Chipset is installed.
Load Optimized Defaults: Use this menu to load the BIOS default values that are factory settings
for optimal performance system operations.
Set Supervisor Password: Use this menu to set Supervisor Passwords.
Set User Password: Use this menu to set User Passwords.
Save & Exit Setup: Save CMOS value changes to CMOS and exit setup.
Exit Without Saving: Abandon all CMOS value changes and exit setup