User manual

84RX1200
Getting Started with SmartWorx
3. For SmartWorx, the Instrument Mode
Selection screen is displayed by default.
To connect the RX to GPS, select Choose
Sensor=GPS.
To show this screen the next time the RX is
turned on, select Show at Startup=Yes.
For SmartWorx, the Instrument Mode
Selection screen is displayed by default.
To connect the RX to TPS, select Choose
Sensor=TPS.
To show this screen the next time the RX is
turned on, select Show at Startup=Yes.
4. Configuring the interface.
For GPS, press CONF (F2) to go to the
Configure SmartAntenna Interface screen.
For TPS, press CONF (F2) to go to the
Configure Instrument Interface screen.
Description