User guide

MultiFRAD II Quick Start Guide
If you enabled Frame Relay in the WAN Ports Default
Setup dialog box, the Frame Relay DLCI Default Setup
dialog box is displayed with all the groups inactive.
When your MultiFRAD is connected to an active frame
relay network service, it can detect DLCIs and the frame
relay management type. However, at this point your
MultiFRAD is not yet communicating with the frame relay
network. Continue with the next step iff you know your
DLCIs and want to add them manually. Otherwise, if you
want them added automatically after your MultiFRAD is
communicating with the frame relay network, proceed to
step 37 to finish installing your software.
26. Click New (+/-) and the Frame Relay New DLCI dialog box
is displayed with the Enter DLCI Number field active.
Enter a DLCI number that was provided by your service
provider at subscription time.
27. Click OK. The Frame Relay DLCI Default Setup dialog box
is displayed with all the groups active and your DLCI
displayed in the DLCIs field.
You can map a protocol stack and/or data port to a DLCI.
18