User guide

Chapter 3: FaxFinder Web Management Interface
Multi-Tech Systems, Inc. FaxFinder Admin User Guide 41
Fax Configuration Section
Modem
Be sure to set the country code for your location as well as look at the routing for your specific setup.
Should you need to adjust some settings for your PBX or local phone lines, many options are available.
Modem Configuration
Modem
Select the number associated with the internal modem that you want to configure. Each modem
can be set individually or you can select All Modems to configure all internal modems to be the
same.
Fax ID
This is what will be used as the fax page header. Typically the fax number of the modem or
company name is entered here so that each page can identify with the number of the sending
party. Please see the FCC website for regulations regarding this.
Country Code
Select the country code you want the modem set to, so that the internal modems will be set to
the required parameters to operate correctly.
Answer On
When routing is set to POTS modem, enter the number of rings that you want the individual
modem to answer after. When, for example, this is set to 2, the internal modem will seize the
line prior to the third ring occurring. When attached to a PBX or when using DTMF routing, the
modem will always go off hook after the first ring to listen for DTMF tones.
Max Extension Digits
Enter the number of digits that the modem will wait for before it sends the string to the PBX.
Routing
This shows the routing method employed by the modem. Many options are available here for
common PBX systems as well as a User Defined option where you can dictate your own settings.