User guide

Chapter 3: FaxFinder Web Management Interface
FaxFinder Administrator User Guide 47
Field
Description
Fax Direction
Use this to specify if this modem line is for inbound faxes only, outbound faxes only,
or both. This setting should match the setting of the analog line/equipment
connected to this port. If the modem has a Fax Direction of outbound, but the
PBX/Telco line connected to it is set to inbound, FaxFinder will not answer inbound
calls.
Routing
Definition
If you selected a vendor pre-defined routing code, it displays in this field. If you
selected User Defined for Routing, enter your own formula/definition in this field.
Routing Definition identifies code elements sent by the PBX so that FaxFinder can
mask information it doesn’t need and identify the extension number it does need.
Key
Click Key for information on the definition.
● n is the variable number for each definition
● For Call Type, Calling Number, and Internal Code, replace n with the
number of digits that you want masked or ignored.
● For Extension digits, replace n with the number of extension digits
used to route inbound faxes to recipients.
● If you are using a predefined mode code that use $x? as the
Extension Digits variable, use the Max DTMF Digits field to define
the number of DID extension digits.
Description
Click this link for an explanation of the current mode code, if any, in the
Routing Definition field.
Error
Correction
Select On to use T.30 error correction with this modem or Off to disable it. Default is
On.
Max Baud Rate
Select the maximum connection (baud) rate that allowed on the modem. Default is
14400.
Smart Dial
Select On to enable Smart Dial or Off to disable it. When Smart Dial is enabled, the
modem waits to detect a dial tone before dialing.
Dial Prefix
Dial prefix is a global setting applied to all outbound calls made from this modem, for
example, 9 to dial an outside line. Any value entered here is automatically the first
number dialed for all outbound faxes, regardless of how a fax is submitted.
Tone Dial
Select On for tone dialing or Off for pulse dialing. Default is On.
Init String
Use this field to define additional AT modem commends needed for your faxing
environment. AT commands entered here will be issued to this modem before every
call on this port, inbound or outbound.
Fax Debugging
If a communication error occurs when FaxFinder attempts to send or receive a fax,
FaxFinder creates a modem log file. This is available through the FaxFinder Web
Management Log menu.