User guide

Chapter 3: FaxFinder Web Management Interface
FaxFinder Administrator User Guide 45
Once you have the zipped file, follow the instructions provided by Multi-Tech Support for sending it in.
Fax Configuration Section
Modem
Use this page to configure modems individually or as a group.
Note: To ensure that your faxes comply with federal regulations branding, refer to the Fax Branding
Statement in Appendix D.
Be sure to set the country code for your location as well as look at the routing for your specific setup.
Should you need to adjust some settings for your PBX or local phone lines, many options are available.
Modem Configuration
Use this section to change fax parameters for each FaxFinder port. Click Save when you have finished
changing parameters.
Note: If you change any modem parameters, that modem will be initialized immediately after you
click save. If the modem is currently in use, initialization will begin when the current call is
completed.
Field
Description
Modem
The internal modem number. The number is based on the FaxFinder model (1 for the
FF130, 1-2 for the FF230, 1-4 for the FF430 and 1-8 for the FF830).
Set modems individually or select All Modems to apply the same configuration to all
modems.
Fax ID
This value is used in the fax page header. Typically, it is the modem’s fax number or
the company name, so that recipients can identify each page with the name or
number of the sender. For regulations about this value, refer to the FCC website.
Country Code
Use this to set the modem’s Country Profile Code. For correct operation, use the