User guide

Chapter 3: FaxFinder Web Management Interface
Multi-Tech Systems, Inc. FaxFinder Admin User Guide 49
Init String
This field is used to define any additional AT modem commands that may be needed for your
faxing environment. AT commands entered here will be issued to this modem prior to every call
that occurs on this port, inbound or outbound.
Fax Debugging
Select O
n or Off for Fax Debugging information to be logged or not.
Regardless of how this parameter is set - when the FaxFinder modem is attempting to send a fax
or is in the process of receiving a fax and a communication error occurs with the remote fax
device, a Modem Log file of the failed fax session is made available via the FaxFinder Web
Management log menus and the Modem Log is attached to any Email that is normally generated
with the delivery or acknowledgment of the fax.
When Fax Debugging is enabled, the log file provided will contain significantly more data about
the fax call. When disabled, the information within the log file is limited.
Warning: Use of this feature should be in a targeted fashion (e.g. enable the feature, reproduce
/ duplicate the problem, gather the log file and then turn the feature off). Fax Debugging On
should only be used at the direction of Multi-Tech Support.
Save button
When you
have entered your information, be sure to click the save button before navigating
away from this page, else your changes will be lost. If any parameter for a modem has been
changed, upon clicking the save button, that modem will be immediately initialized; unless it's
currently in use -then it will be applied after the current call is completed.
Modem Configuration Table
This section
displays the current settings of each fax modem in your FaxFinder.