User guide

Chapter 3: FaxFinder Web Management Interface
Multi-Tech Systems, Inc. FaxFinder Admin User Guide 46
Fax Configuration Section
Modem
Be sure to set the country code for your location as well as look at the routing for your specific setup.
Should you need to adjust some settings for your PBX or local phone lines, many options are available.
Note: Please read the Fax Branding Statement in Appendix E for important legal information about
faxes.
Modem Configuration
Use the
Fields in this section to change or set the fax parameters for each port in your FaxFinder.
Modem
Select
the number associated with the internal modem that you want to configure. Each modem
can be set individually or you can select All Modems to configure all internal modems to be the
same.
Fax ID
This is wha
t will be used as the fax page header. Typically the fax number of the modem or
company name is entered here so that each page can identify with the number of the sending
party. Please see the FCC website for regulations regarding this.
Country Code
This sele
cts the Country Profile Code given to the modem. For correct operation set this
parameter to match the country the FaxFinder will be deployed in.
Answer On
When
the "Routing" parameter is set to "POTS Line" enter the number of rings that you want
the individual modem to answer after. When, for example, this is set to 2, the internal modem
will seize the line after two full ring sequences have been detected. When the "Routing"
parameter is set to "DTMF Digits" or one of the "PBX mode code" options, the value specified in
this field is not used. PBX mode code and DTMF Digit routing will always pick up after 1 full ring
detect sequence.