User guide

Server Installation Multi-Tech FaxFinder Quick Start
12
3. Connect FaxFinder to Ethernet Network.
Plug one end of your RJ45 ethernet cable into the FaxFinder’s
ethernet jack and the other end into your network ethernet hub.
This ethernet cable is not included with your FaxFinder unit.
Line 2
Line 1
Ethernet
10/100
POWER
5Vdc
Caution: Before connecting to the Ethernet Network, make
sure that the network to which you are connecting the
FaxFinder is not a 192.168.2.x subnet. Because the
FaxFinder’s factory default IP address is 192.168.2.1,
connecting it to a network that has a different device at
that same IP address would cause data interference.
If it is a 192.168.2.x subnet, connect from the
Administrative PC to the FaxFinder until the FaxFinder’s
IP address has been configured. Thereafter, connect the
FaxFinder into the network with an ordinary RJ45 cable.