Specifications

BASIC FAXFINDER CONFIGURATION
Field Description
Routing Definition If you selected a vendor pre-defined routing code, it displays in this field. If you selected User
Defined for Routing, enter your own formula/definition in this field. Routing Definition
identifies code elements sent by the PBX so that FaxFinder can mask information it doesn't
need and identify the extension number it does need.
Key
■ n is the variable number for each definition
■ For Call Type, Calling Number, and Internal Code, replace n with
the number of digits that you want masked or ignored.
■ For Extension digits, replace n with the number of extension digits
used to route inbound faxes to recipients. If you are using a
predefined mode code that uses $x? as the Extension Digits
variable, use the Max DTMF Digits field to define the number of
DID extension digits.
Description Explains the current mode code, if any, in the Routing Definition field.
Max Baud Rate Select the maximum connection (baud) rate that allowed on the modem. Default is 14400.
Dial Prefix This is a global setting applied to all outbound calls made from this modem, for example, 9 to
dial an outside line. Any value entered here is automatically the first number dialed for all
outbound faxes, regardless of how a fax is submitted.
Init String Use this field to define additional AT modem commends needed for your faxing environment.
AT commands entered here will be issued to this modem before every call on this port,
inbound or outbound.
Fax ID This value appears in the fax page header. Typically, it is the fax number or the company
name, so that recipients can identify each page with the sender's name or number. For Fax ID
regulations, consult the FCC website.
Max Extension Used when Routing is set to DTMF Digits or a PBX mode code. Enter a value that matches the
Digits number of digits to be passed by the line/PBX to the FaxFinder modem port. The supported
range length of a DTMF string is from 1 to 15 digits.
Fax Direction Specify if this modem is for inbound faxes only, outbound faxes only, or both. This setting
should match the setting of the analog line/equipment connected to this port. If the modem
is set to outbound, but the PBX/Telco line connected to it is set to inbound, FaxFinder will not
answer inbound calls.
Error Correction Select On to use T.30 error correction with this modem or Off to disable it. Default is On.
Smart Dial Select On to enable Smart Dial or Off to disable it. When Smart Dial is enabled, the modem
waits to detect a dial tone before dialing.
FaxFinder
®
Fax Server FF240, FF440, FF840 Administrator Guide 35