Specifications

ADVANCED CONFIGURATION
Field Description
Password Enter authentication password required for SNMP V3. Must be between 8-32 characters
long.
Confirm Password Re-enter the authentication password.
Configuring SNMP Allowed Addresses
For SNMP versions 1 and 2C, configure allowed IP addresses to specify which networks are allowed to
communicate with FaxFinder. By default, all IP addresses are allowed. As soon as you add one IP address, access
through SNMP V1/V2C will be limited by the IP address list.
Note: Does not apply to SNMP version 3
1. Go to System Configuration > SNMP .
2. Click to open Allowed IP Addresses, then click Add.
3. Enter Network IP address and netmask in the format of ###.###.###.#/XX, where the ###.###.###.###
represents the IP address and the XX represents the netmask. For example, 192.168.0.0/16.
4. Click Save.
5. Repeat Steps 1-3 for each IP address or range you want to add.
Deleting IP Addresses
To delete IP addresses
1. On the System Configuration > SNMP page, click Delete, under Allowed IP Addresses.
2. Confirm the deletion when prompted.
Setting SNMP Traps
Use SNMP traps send the SNMP notifications available in FaxFinder. To configure SNMP traps:
1. Check Enable Traps.
2. Enter Destination IP address, in the format ###.###.###.###.
3. Select SNMP version Options are:
SNMP V1
SNMP V2C
SNMP V3
4. Enter additional trap settings as required for the selected SNMP version. Refer to SNMP Trap Settings for
details.
5. Click Save.
6. Click Send Test Trap to verify that SNMP Trap Settings are configured properly and Trap Destination is
able to receive notifications from FaxFinder.
7. All traps are selected by default. Uncheck any trap that you do not want to use. Refer to SNMP Traps for
details
8. Click Save.
56 FaxFinder
®
Fax Server FF240-IP Administrator Guide