Specifications

CELLULAR INFORMATION
Cellular Information
Antenna System Cellular Devices
The cellular/wireless performance depends on the implementation and antenna design. The integration of the
antenna system into the product is a critical part of the design process; therefore, it is essential to consider it early
so the performance is not compromised. If changes are made to the device's certified antenna system, then
recertification will be required by specific network carriers.
CDMA Antenna Information
CDMA devices were approved with the following antenna:
Exceltek Electronics, Ltd.
Description: GSM quad band antenna
Part number: C0081-ANG0002
Multi-Tech part number: 45009713L
CDMA Antenna Requirements/Specifications
Frequency range 824-894 MHz / 1850-1900 MHz
Impedance 50 ohm
VSWR Make sure VSWR does not exceed 2.0.1 at any point
across the bands of operation
Typical radiated gain radiation 2 dBi on azimuth plane
Radiation Omni directional
Polarization Vertical
Coax Cables Specifications
Category Description
Cable type Coaxial cable
Attenuation <1.0 db
Connector impedance 50 ohm
Maximum cable length 16 inches (40 cm)
SMA-to-UFL and RSMA-to-UFL Coaxial Cables
Note:
RSMA cables are not supported for CDMA products.
The Developer Kit includes the following cables:
8 QuickCarrier™ USB-E MT100UCC-C2 Developer Guide