User guide

ENHANCED IP STACK AT COMMANDS
AT Commands for EV-DO-EV3 Modems
156
Parameters and Values
<da> String type, destination address.
<subj> String type, subject of message.
<att> Attached image flag. Not supported.
0 Don’t attach any image.
1 Attach the last snapshot taken.
The device responds to the command with the prompt '>' and waits for the
message body text.
To complete the operation send Ctrl-Z char (0x1A hex). To exit without writing the
message send ESC char (0x1B hex).
If e-mail message is successfully sent, the response is OK.
If message sending fails for some reason, an error code is reported.
Notes
 Ensure that no other commands are issued during command execution.
 To avoid malfunctions, wait for the OK or ERROR / +CMS ERROR:<err> response before issuing further
commands.
Example
AT#SEMAIL=”[e-mail]”,”subject of the mail”
>message body… this is the text of the mail message…
CTRL-Z
..wait..
OK
Message has been sent.
E-mail CDMA Context Activation #EMAILACT
Execute command deactivates and activates the CDMA context.
Read command reports the current status of the CDMA context for the e-mail, in the format:
#EMAILACT: <status>
where:
<status>
0 CDMA context deactivated.
1 CDMA context activated.
Test command returns the OK result code.
Syntax
Command Command type
AT#EMAILACT=[<mode>] Execute
AT#EMAILACT=? Test