User guide

CUSTOM AT COMMANDS
121 AT Commands for EV-DO-EV3 Modems
Show Address #CGPADDR
Execute command returns either the IP address for the current activated CDMA PDP context.
<cid> - Context identifier
Test command returns <cid> when the modem gets the IP address, otherwise return only OK result.
Syntax
Command Command type
AT#CGPADDR=<cid> Execute
AT#CGPADDR=? Test
Notes
 Only one context ID(1) is supported.
 If no <cid> is specified, the addresses for all defined contexts are returned.
Example
AT#SGACT=1,1
+IP: xxx.yyy.zzz.www
OK
AT#CGPADDR=?
#CGPADDR: (1)
OK
AT#CGPADDR=1
#CGPADDR: 1,”xxx.yyy.zzz.www”
OK
Power Saving Mode Ring #PSMRI
Set command enables or disables the Ring Indicator pin response to an URC message while modem is in power
saving mode.
If enabled, a negative going pulse is generated when URC message for specific event is invoked. The duration of
this pulse is determined by the value of <x>.
Read command reports the duration in ms of the pulse generated, in the format:
#PSMRI: <x>
Test command reports the supported range of values for parameter <x> .
Syntax
Command Command type
AT#PSMRI= <x> Set
AT#PSMRI? Read
AT#PSMRI=? Test